CR PLASMA Oxy Acetylene Cutting Machine
The CR PLASMA system has all the required control capacity to fully manage an Oxy Acetylene cutting head. The controller can run a dual process head by switching between a plasma process and an Oxy process in the one system. Typically Oxy cutting comes into its own on much thicker steel parts where the power required to run a plasma becomes prohibitive to its installation and cost to run
Specifications
OXY FUEL cutting head
Controller can program and control pressure and timings of the gas flows into the Oxy system to optimise cutting
Capacitive height Control
The system has an optional capacitive height control sensor system to allow fully auto height control regulation when the cutting process is active and the Oxy head is in motion
Twin process
The CR PLASMA controller allows two Z axes to be controlled on the one machine. The software can switch between Oxy cutting and plasma cutting. The two Z axis simply switch pending which ptocess is active.
Gallery
OXY cutting is typically used when much thicker steel cutting is required that makes plasma cutting less competitive on edge finish and power consumption. See below for some cutting using the Oxy system fitted to a CR PLASMA POWERCUT machine
Videos
…
OXY fuel cutting on the CR PLASMA system.
CR PLASMA OXY FUEL CUTTING
Fully programmable control of all the gas flow feed to the cutting head
Capacitive height control option for height regulation
Controller can run dual process with two Z axes installed.
Plasma Z axis comes down for plasma cutting or Oxy Z axis comes down for Oxy cutting
Can be fitted to all machines in the CR PLASMA Range